| General |
| Product Name: |
SwitchLinc Dimmer (Dual-Band) |
| Brand/Manufacturer: |
INSTEON |
| Product Number and UPC: |
White |
2477D |
689076401746 |
| Almond |
2477DAL |
813922010534 |
| Light Almond |
2477DLAL |
813922011579 |
| Black |
2477DBK |
813922010541 |
| Grey |
2477DGY |
813922010565 |
| Ivory |
2477DIV |
813922010572 |
| Brown |
2477DBR |
813922010558 |
| Warranty: |
2 years, limited |
| Operation |
| On-Levels: |
32 locally, increments of 1% with software |
| Ramp Rates: |
0.125 to 9 seconds if programmed locally, 0.125 seconds to 8 minutes if programmed remotely |
| LED Indicator: |
9 White LEDs, one Red/Green Status LED |
| Operation Modes: |
INSTEON only, X10 only, INSTEON and X10 Combo Mode |
| Combo Mode Message Order: |
INSTEON, INSTEON cleanup, X10 |
| Multi-Way Circuit Support: |
One SwitchLinc Dimmer controls load, Cross-Link any number of SwitchLinc Dimmers or other INSTEON Controllers |
| Setup Memory: |
Non-volatile EEPROM |
| INSTEON |
| INSTEON Addresses: |
1 hard-coded out of 16,777,216 possible |
| INSETON Links: |
417 |
| INSTEON Powerline Frequency: |
131.65 KHz |
| INSTEON Minimum Transit Level: |
3.2 Vpp into 5 Ohms |
| INSTEON Minimum Receive Level: |
10 mV |
| INSTEON Messages Repeated: |
Yes |
| Radio Frequency: |
915 MHz |
| Software configurable: |
Yes |
| Mechanical |
| Paddle Type: |
True rocker action |
| Wire Nuts: |
4 included |
| Mounting: |
Mounts in single or multiple-ganged junction box. Control 200 W less load for each immediately adjacent SwitchLinc Dimmer installed. For example, 600 W load control becomes 400 W with another dimmer to the immediate right or left. Use a triple-gang box with a mechanical switch in the center to avoid de-rating. |
| Dimensions: |
4.1" H x 1.8" W x 1.2" D |
| Weight: |
3.6 oz |
| Operating environment: |
Indoors |
| Operating temperature range: |
32° to 104°F (0° to 40°C) |
| Operating humidity range: |
0-85% relative humidity |
| Electrical |
| Voltage: |
100VAC to 277VAC |
| Frequency: |
50/60Hz auto-detected at power-up |
| Neutral Wire: |
Required |
| Power Wire Leads: |
6", 16 AWG, stranded,600V, 105 °C insulation, ends stripped and tinned, LINE (black), LOAD (red), NEUTRAL (white) |
| Maximum Amps: |
5 amps |
| Ground Lead: |
6", 18 AWG, stranded, bare copper |
| Maximum Load: |
600 Watts (uses 12-Amp triac dimmer) |
| Standby power consumption: |
0.59 Watts |
| Safety approved: |
Safety tested for use in USA and Canada (ETL #3017581) |
| X10 Features (Power-Line Only) |
| X10 Primary Address: |
1 optional (comes unassigned) |
| X10 Scene Address: |
255 possible |
| X10 Status Response: |
Supported |
| X10 Resume Dim: |
Supported (by setting Local On-Level to zero) |
| X10 Powerline Frequency: |
120 KHz |
| X10 Minimum Transmit Level: |
3.2 Vpp into 5 Ohms |
| X10 Minimum Receive Level: |
20mV into 5 Ohms |
| X10 Messages Repeated: |
No |
